From economy 7, 9 and 10 to time-of-use tariffs
Contents |
[edit] Economy 7, 9, 10 and others
[edit] Economy 7 (E7)
Economy 7 (E7) is a reduced rate off-peak differential tariff for electricity consumed during 7 hours overnight, when the electricity is in low demand and at its base load. The tariff requires a special meter with two different readings one low (for the night rate) and one normal (for the standard day rate). It is usually found in homes that use electricity for both heating and hot water, often because the local area does not have access to gas.
The term Economy 7 was coined by Jon Marshall, first mentioned of in 1978 and recorded in the book "Electricity Supply in the UK: A chronology by the now-defunct association of nationally-owned electricity companies; The Electricity Council. "A new off-peak tariff known as the 'Economy 7' tariff was introduced in October [1978]. It featured a seven-hour night rate some 20 per cent cheaper than most night-time tariffs, made possible by economies in the night-time operation of the system."
Night storage heaters are often installed alongside E7. They contain high thermal mass materials such as bricks, which are heated up overnight when the electricity rate is cheaper, and this heat is released during the day, in some cases with a small electrical fan (running on the normal tariff) to act as a blow heater. In standard night storage heaters once the bricks have exhausted their heat and cooled down the the heat source has run out until it can be heated again overnight, but some models also include a standard heating element meaning they can be used during the day but at the higher tariff.
[edit] Economy 9 (E9), 10 (E10) and others
There are a number of other reduced rate or multi-rate tariffs which are usually determined by geographical area in the UK as well as the type of meter that is installed. The most similar by name and nature is Economy 9 (E9) which offers 9 hours of reduced rate tariff, as opposed to 7 hours. Off-peak (type 1, type 2 and type U), similarly offer differing rates between day and night as does Warmwise, offering 8 hours at a reduced rate.
These types of metering and tariff systems might also be referred as a complex tariffs, along with complex meters, because of the different rates and ways of measuring that they offer.
Economy 10 tariff (E10), is yet more complex as it offers three different rates amounting in total to 10 hours, such as; three off-peak hours in the afternoon (e.g. 1pm - 4pm), two in the evening (e.g. 8pm - 10pm) and five overnight (e.g. 12am - 5am). Heatwise runs in the Midlands on a similar principle.
It is now possible to instal smart meters that also run on economy 7, 9 or 10 tariffs although they are less common.
[edit] Balancing demand and supply
With increasing pressure to reduce carbon emissions, which includes reducing the reliance on gas, staggering the charge rates can encourage a better spread in the use of electricity and can be an important aspect to consider in terms of energy management. In general the notion of spreading the load in terms of energy use can help with reducing peaks in demand (as well as troughs), which in turn help in the introduction of renewables and in providing a more consistent grid supply. Although less common today, because of changes in media communication and the influence of the Internet on viewing times, the principle is best described by the term TV pickup - showing how event related behaviour when aggregated can have significant impact on demand.
In more recent years the difference between day and night rates has increased, with reductions of around 30%, however in some cases complex tariffs can also result in an increase in the standing (or fixed) charge as well as an increase in daytime rates.
[edit] Smart meters
The gradual introduction of smart meters has allowed an increase in the granularity of data available around energy use, meaning users and suppliers can measure use levels up to every half hour. This means that the grid can better assess use patterns in near to real time, whilst energy companies can offer tariffs that better match supply and demand. So in effect they can offer complex tariffs, similar to economy 7, 9 ,10 or other differential tariffs, based on specific times. There are over 20 million domestic smart meters now installed in homes in Great Britain, this smart meter data is set to become a crucial tool for energy research, energy management and potentially in the way electricity use is charged.
The main advantage to the consumer is that similar to the older variable rate charging systems they can be offered as time-of-use tariffs, though in practice this has and continues to be less than plain sailing. Whilst as early as 2017 there were reports of some of the earliest time-of-use tariffs, by 2020 an increasing number of households had smart meters installed, although this was hampered by the pandemic. At the end of 2021 Business, Energy and Industrial Strategy (BEIS) reported that over 50% of all meters in the Great Britain were smart meters, however these were divided into 3 types; SMETS1 (15.3 million), SMETS2 (11.1 million) and 1.3 million with advanced meters.
[edit] Smart or time-of-use tariffs
Time-of-use tariffs, also known as smart electricity tariffs, are possible once a customer has a smart energy meter that records energy consumption on a half-hourly basis. Energy companies, knowing the half-hourly energy use can offer a variety of new types of off-peak tariffs that charge different rates for electricity depending on the time of day according to the general demand at the time and the supply available.
The options described above in effect have similar goals in trying to balance the demands for energy that are placed on the grid and the supply of energy available from the grid, which may increasingly vary with the expansion of renewables such as wind and solar.
Whilst the meter system installation has in general progressed well, the offering and uptake of time-of-use tariffs has been slow, partly blamed on the concurrent disruption to the energy markets that occurred after the Russian invasion of Ukraine, leading to the energy crisis. Whilst significant profits were reported by larger energy companies, many smaller energy companies left the market, reducing confidence and reluctance to offer the new design of tariffs. However in 2023 a number of energy companies were offering time-of-use tariffs, often directly related to EV (electric vehicle) users and the need for car charging over night at off-peak times.
[edit] Demand Flexibility Service
A service recently trialled by the National Grid in 2022 called the Demand Flexibility Service (DFS) actively engaged with large numbers of users during what they called events, and rewarded them for not using power during certain peak winter periods. The events were preset, known periods when demand could potentially be higher than supply, for example during darker winter months. The service informed consumers of the events and rewarded them for delaying their usage until the grid had higher supply or less demand. This helped avoid potentially bringing carbon intensive power plants on line, possible overloads and potential power cuts. The trial was reported as a success by the National Grid ESO - see "World-first Demand Flexibility Service exceeds expectations with businesses saving thousands of pounds while reducing carbon emissions" in January of 2023.
[edit] Related articles on Designing Buildings
- Articles about electricity.
- ECA articles.
- ECA calls on Government to reform and rebalance energy levies and avoid cost of living crisis.
- Electric.
- Electrical appliance.
- Electrical consumption.
- Electrical energy.
- Electrical equipment.
- Electrical installation.
- Electrical power.
- Electrical safety.
- Electrician.
- Electricity bill.
- Energy cost.
- Energy price crisis: ECA calls for energy levy reform.
- Energy tariffs.
- Fuse box.
- Glossary of electrical terms.
Featured articles and news
Twas the site before Christmas...
A rhyme for the industry and a thankyou to our supporters.
Plumbing and heating systems in schools
New apprentice pay rates coming into effect in the new year
Addressing the impact of recent national minimum wage changes.
EBSSA support for the new industry competence structure
The Engineering and Building Services Skills Authority, in working group 2.
Notes from BSRIA Sustainable Futures briefing
From carbon down to the all important customer: Redefining Retrofit for Net Zero Living.
Principal Designer: A New Opportunity for Architects
ACA launches a Principal Designer Register for architects.
A new government plan for housing and nature recovery
Exploring a new housing and infrastructure nature recovery framework.
Leveraging technology to enhance prospects for students
A case study on the significance of the Autodesk Revit certification.
Fundamental Review of Building Regulations Guidance
Announced during commons debate on the Grenfell Inquiry Phase 2 report.
CIAT responds to the updated National Planning Policy Framework
With key changes in the revised NPPF outlined.
Councils and communities highlighted for delivery of common-sense housing in planning overhaul
As government follows up with mandatory housing targets.
CIOB photographic competition final images revealed
Art of Building produces stunning images for another year.
HSE prosecutes company for putting workers at risk
Roofing company fined and its director sentenced.
Strategic restructure to transform industry competence
EBSSA becomes part of a new industry competence structure.
Major overhaul of planning committees proposed by government
Planning decisions set to be fast-tracked to tackle the housing crisis.
Industry Competence Steering Group restructure
ICSG transitions to the Industry Competence Committee (ICC) under the Building Safety Regulator (BSR).
Principal Contractor Competency Certification Scheme
CIOB PCCCS competence framework for Principal Contractors.
The CIAT Principal Designer register
Issues explained via a series of FAQs.
Comments
[edit] To make a comment about this article, click 'Add a comment' above. Separate your comments from any existing comments by inserting a horizontal line.