Felt lap vent
A felt lap vent is normally a moulded plastic product which is designed to allow air to pass through the lap between two layers of the felt which lies on top of the rafters, beneath the battons which hold the tiles or slates. It is a retrofit solution for houses which have cold roofs and suffer from moisture build up in the attic or loft space from moist warm air rising from the living spaces below. These houses are normally older constructions where roof felt has been used which is not breathable rather than newer construction that may use a membrane that prevents water ingress but lest moist air out ie breathabe mebranes.
In a cold roof scenario, the insulation and air tightness barrier is normally in line with the ceiling of the upper most rooms (rather than the pitch of the roof). Keeping the uninsulated roof space ventilated can be important to prevent moisture build up, mould and potential damage, particularly where non breathable felt or bitumen products are used. Increased moisture from warm air and activity in living spaces below can build up in the cold roof space above, condense on surfaces and with out good air flow can cause structural damage over longer periods.
Felt laps are one way of introducing air flow into a cold roofs to remove moisture build up, other options are tile, slate, soffit, fascia and ridge vents. In some cases where levels of insulation are increased above the ceiling level this can restrict air flow that traditionally would have come through the sofits or barge board ventilators. Felt laps can be installed higher up the roof pitch, where ever layers of felt over lap, thus not being restricted by the increased levels of insulation and without the need to remove or replace roof surfaces such as slate or tiles.
For further information on the ventilation of cold roofs guidance should be sought in Aproved Document C "Site preparation and resistance to contaminants and moisture" section C2.
[edit] Related articles on Designing Buildings
Featured articles and news
The Architectural Technology Awards
The AT Awards 2025 are open for entries!
ECA Blueprint for Electrification
The 'mosaic of interconnected challenges' and how to deliver the UK’s Transition to Clean Power.
Grenfell Tower Principal Contractor Award notice
Tower repair and maintenance contractor announced as demolition contractor.
Passivhaus social homes benefit from heat pump service
Sixteen new homes designed and built to achieve Passivhaus constructed in Dumfries & Galloway.
CABE Publishes Results of 2025 Building Control Survey
Concern over lack of understanding of how roles have changed since the introduction of the BSA 2022.
British Architectural Sculpture 1851-1951
A rich heritage of decorative and figurative sculpture. Book review.
A programme to tackle the lack of diversity.
Independent Building Control review panel
Five members of the newly established, Grenfell Tower Inquiry recommended, panel appointed.
Welsh Recharging Electrical Skills Charter progresses
ECA progressing on the ‘asks’ of the Recharging Electrical Skills Charter at the Senedd in Wales.
A brief history from 1890s to 2020s.
CIOB and CORBON combine forces
To elevate professional standards in Nigeria’s construction industry.
Amendment to the GB Energy Bill welcomed by ECA
Move prevents nationally-owned energy company from investing in solar panels produced by modern slavery.
Gregor Harvie argues that AI is state-sanctioned theft of IP.
Heat pumps, vehicle chargers and heating appliances must be sold with smart functionality.
Experimental AI housing target help for councils
Experimental AI could help councils meet housing targets by digitising records.
New-style degrees set for reformed ARB accreditation
Following the ARB Tomorrow's Architects competency outcomes for Architects.
BSRIA Occupant Wellbeing survey BOW
Occupant satisfaction and wellbeing tool inc. physical environment, indoor facilities, functionality and accessibility.