Power surge
A power surge is when an unusually high voltage occurs in an electrical system for a short period. It may also be referred to as a transient surge because it involves a transient wave of voltage, current or power which usually occurs between the normal waves of voltage. The over voltage can be additive or subtractive with positive or negative polarity lasting less than a half-cycle, or at little as 50 microseconds but surges can reach 6000 Volts and 3000Amps which can cause damage.
Power surges often occur after power cuts or blackouts as systems are reinstalled or turned on again. Lightening strikes can cause power cuts but can also cause power surges as the systems absorb the excess electrical power of the lightening strike, which can damage equipment plugged into the circuit. Other common causes of power surges are faulty wiring and when systems are overloaded or drawing too much power.
Occurrences where systems draw too much power can be localised to individual buildings where for example too many pieces of equipment are plugged into the same socket, drawing too much power which can cause damage or in some cases fire. These events can also occur on a wider scale such as for example during what is known as TV pickup, which describes the phenomenon of many people demanding power at the same time, which might happen during commercial TV breaks when viewers all put the kettle on at the same time. One example of this occurred at the end of the FIFA World Cup semi-final after a penalty shoot-out between England v West Germany in 1990 when the UK demand at that point was 2800 megawatts.
Common methods exist to deal with power surges, most of which aim to earth any excess power from a lightening bolt safely to the ground rather than through an electrical system, many of which are written into installation guidance or recommended by the building regulations such as lightening protection systems. Other practical measures to avoid damage to individual equipment during a power surge that occurs after a power cut (or during a storm with likely lightening bolts) include unplugging equipment from those circuit, thus removing the risk to individual appliances or earthing individual appliances within the circuit.
[edit] Related articles on Designing Buildings
Featured articles and news
Gregor Harvie argues that AI is state-sanctioned theft of IP.
Heat pumps, vehicle chargers and heating appliances must be sold with smart functionality.
Experimental AI housing target help for councils
Experimental AI could help councils meet housing targets by digitising records.
New-style degrees set for reformed ARB accreditation
Following the ARB Tomorrow's Architects competency outcomes for Architects.
BSRIA Occupant Wellbeing survey BOW
Occupant satisfaction and wellbeing tool inc. physical environment, indoor facilities, functionality and accessibility.
Preserving, waterproofing and decorating buildings.
Many resources for visitors aswell as new features for members.
Using technology to empower communities
The Community data platform; capturing the DNA of a place and fostering participation, for better design.
Heat pump and wind turbine sound calculations for PDRs
MCS publish updated sound calculation standards for permitted development installations.
Homes England creates largest housing-led site in the North
Successful, 34 hectare land acquisition with the residential allocation now completed.
Scottish apprenticeship training proposals
General support although better accountability and transparency is sought.
The history of building regulations
A story of belated action in response to crisis.
Moisture, fire safety and emerging trends in living walls
How wet is your wall?
Current policy explained and newly published consultation by the UK and Welsh Governments.
British architecture 1919–39. Book review.
Conservation of listed prefabs in Moseley.
Energy industry calls for urgent reform.
Comments
[edit] To make a comment about this article, or to suggest changes, click 'Add a comment' above. Separate your comments from any existing comments by inserting a horizontal line.