Amendment 3 BS 7671 Requirements for Electrical Installations IET Wiring Regulations
The British Standards Institution (BSI) publishes standards and provides a range of books, self-assessment tools, conferences and training services. It also represents UK economic and social interests in European and international standards organisations.
BS 7671 Requirements for Electrical Installations. IET Wiring Regulations, sets the standards for electrical installations in the UK. It is published by BSI and the Institution of Engineering and Technology (IET).
On January 1 2015, BS 7671:2008+A3:2015, Amendment No. 3 to the 17th Edition was published. It included changes relating to:
- Consumer units.
- Wiring in escape routes.
- Changes to earth fault loop impedances for all protective devices.
- Updated EIC and EICR forms.
- Changes to definitions.
Amendment 3 came into effect on 1 July 2015, however, the changes in relation to consumer units did not come into effect until 1 January 2016.
From this point, consumer units and similar switchgear assemblies have to comply with BS EN 61439-3 Low-voltage switchgear and controlgear assemblies. Distribution boards intended to be operated by ordinary persons (DBO).
Consumer units are pieces of equipment located where the incoming mains supply is fed to the individual domestic circuits. It typically includes protection and isolation hardware.
The amendment in relation to consumer units has been made in response to the increase in the number of fires which are thought to have involved consumer units with thermoplastic enclosures in which arcing on cables due to poor electrical connections caused overheating.
The amendment requires that consumer units contain fires, either being constructed using a non-combustible material or being contained within a cabinet constructed using a non-combustible material. It applies to consumer units and similar switchgear assemblies inside domestic premises. It does not apply to non-domestic installations or to outside installations.
[edit] Related articles on Designing Buildings
- Arcing.
- Articles by the Electrical Contractors' Association (ECA).
- Approved document P.
- Consumer unit.
- Electrical appliance.
- Electrical component.
- Electrical contractor.
- Electrical installation.
- Electrical safety.
- Electrician.
- Glossary of electrical terms.
- Grommet.
- IET announces release of 18th Edition Amendment 2.
- Institution of Engineering and Technology.
- International Organisation for Standardisation.
- Kitemark.
- Lock out tag out LOTO.
- Modular housing and electrical circuitry.
- Premises wiring system.
- Protected circuit.
- Publicly available specification.
- Ring circuit.
- Right to Repair law.
- Safe isolation for low voltage.
- SELECT Scotland's Electrical Trade Association.
- The Future of Electricity in Domestic Buildings.
Featured articles and news
Top 50 firms awarded 52bn of projects in the last year
New engineering data shows.
Enhancing construction site reporting efficiency
Through digitisation and the digital revolution.
Noise in the built environment
BSRIA guide TG 20/2021.
17,000 people suffer conditions as a result of exposure to excessive noise at work.
Turning down the noise: Auditory health
A pervasive risk with far-reaching consequences.
UK Construction Week, London is here !
Debuting major international pavilions and much more.
Getting the most out of heat pumps and heating
How heat pumps work and how they work best.
Plumbing and heating for successful retrofit and renovation
Low temperature underfloor systems and heat pumps.
Cost-of-living crisis and home improvement plans
Starting on the right footing and top tips for projects.
Delays on construction projects
Types, mitigation and the acceleration of works.
From Chaucer to Fawlty Towers.
Electrotechnical excellence, now open for entries.
Net zero electricity grids BSRIA guide NZG 5/2024
Outlining the changes needed to transition to net zero.
CIOB Global Student Challenge 2024
Universitas Indonesia wins for second year running.
ECA 2024 Apprentice of the Year Award
Entries open for submission until May 31.